|
The
QoIP transmitter and receiver transport six network cues and
six independent relays point-to-point/multipoint over IP. Applications
include Remote Control; Zoned Commercial Insertion for cable television;
Commercial Insertion for DBS Feeds in Bars, at Hotels, etc.; DTMF Cue
Transport; and GPI Transport.
The GPI-100 transmitter and receiver transport twelve independent
relays point-to-point/multipoint over IP. Applications include Remote
Control, Status Monitoring, Emergency Alert, Syndex, Commercial Insertion
at remote sites, and other switching requirements.
Both the QoIP and the GPI-100 include software switches
that can be programmed to transmit a packet with the device settings
every second, reboot every three seconds if the Ethernet link goes down,
and add a time stamp each time a command is transmitted.
The DTMF-TX and DTMF-RX transport a relay over an audio
signal via DTMF and convert DTMF to a relay or a relay to DTMF. Program
audio is muted during transmission. The tone sets are factory pre-programmed
and can be changed in the field by changing an internal socketed IC.
The DTMF-RX can be programmed for a latching or momentary output.
Use the DTMF-TX by itself to convert a relay to DTMF tones. Use
the DTMF-RX by itself to convert DTMF tones to latching or momentary
relay.
The VAGC-100 is an NTSC/PAL video AGC that maintains video at
140 IRE, sync at 40 IRE, and removes low frequency hum bars.
The TS-201 is a DTMF Test Set used by itself or as part of the
TS Package. It displays the tone sequence of an incoming DTMF
stream, the highest audio level received, and logs, date, and time stamps
the signal. This stored data can be output directly to a printer or
retrieved via modem and included software.
The TS-202 is a DTMF generator used by itself or as part of the
TS Package. It generates both low speed and high speed tones.
The high speed output emulates cues transported over satellite. You
can adjust the TS-202 output level locally.
The TS-211 is a composite baseband, video, and audio level meter
used by itself or as a part of the TS Package. It measures the
composite baseband output of a satellite receiver, video in peak-to-peak,
and audio in both RMS and relative peak.
The TS Package includes the TS-201, TS-202, and
TS-211 as a discounted set.
The VLB-100 removes selected lines from 10 to 21 in both fields
of the vertical interval of a video signal.
|
